Lenovo E200 Manuale Utente Scaricare il pdf (Pagina 113)

Replacing the power switch or LED assembly

Attention

Do not open your computer or attempt any repair before reading and understanding the

“Important safety information” in the ThinkCentre Safety and Warranty Guide that came with

your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:

http://www.lenovo.com/support

1. Disconnect the power switch/LED assembly cable from the system board. See

“Identifying parts on the system board” on page 85.

2. Remove the front bezel. See “Removing and replacing the front bezel” on page

88.

3. Remove the power switch/LED assembly by disconnecting it from the inside of

the bezel.

4. Install the new power switch/LED assembly into the bezel.

5. Route the cable for the new power switch/LED assembly through the hole in

the chassis and to the system board.

6. Reinstall the bezel. See “Removing and replacing the front bezel” on page 88.

7. Reconnect the power switch/LED cable to the system board.

8. Go to “Completing the FRU replacement.”

Completing the FRU replacement

After replacing FRUs, you need to install any removed parts, replace the cover, and

reconnect any cables, including telephone lines and power cords. Also, depending

on the FRU that is replaced, you might need to confirm the updated information in

the Setup Utility program.

Note: When the power cord is first plugged in, the computer might appear to turn

on for a few seconds and then turn off. This is a normal sequence to enable

the computer to initialize.

1. Ensure that all components have been reassembled correctly and that no tools

or loose screws are left inside the computer.

2. Make sure that the cables are routed correctly before installing the computer

cover.

3. Replace the covers that were removed and secure them with the thumb screws.

4. Reconnect the external cables and power cords to the computer. See “Locating

the connectors on the rear of your computer” on page 82.

5. If you have replaced the system board, you must update (flash) the BIOS. See

“Flash update procedures” on page 111.

6. Some FRU replacements require the configuration to be updated. See Chapter 6,

“Using the Setup Utility,” on page 49.

Chapter 8. Replacing FRUs (Type 7848) 107

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 123 124

Nessun commento

Lenovo E200 Manuale Utente Pagina 113